| 李冬阳.12R22.5全钢无内胎子午线轮胎成型工艺的改进[J].橡胶科技,2021,19(11):0555-0557. |
二维码（扫一下试试看！） |
| 12R22.5全钢无内胎子午线轮胎成型工艺的改进 |
| Improvement of Building Process of 12R22.5 All-steel Tubeless Radial Tire |
| 投稿时间：2021-01-06 修订日期：2021-01-27 |
| DOI：10.12137/j.issn.2095-5448.2021.11.0555 |
| 中文关键词: 无内胎全钢子午线轮胎 成型工艺 改进 胎侧 三角胶 气泡 |
| 英文关键词: all-steel tubeless radial tire building process improvement sidewall apex air bubble |
| 基金项目: |
| 中图分类号: |
|
| 摘要点击次数: 1353 |
| 全文下载次数: 583 |
| 中文摘要: |
| 采取调整三角胶胶片、胎侧胶片的方法对12R22.5全钢无内胎子午线轮胎成型工艺进行改进。通过增大三角胶上胶片宽度、减小胎侧上胶片宽度，同时设定合理的端点纹差，胎坯胎侧气泡减少，成型工序效率提高，成品轮胎返修率大幅度降低；成品轮胎的静负荷性能、耐久性能和高速性能变化不大，外观改善，生产成本降低。 |
| 英文摘要: |
| The building process of 12R22.5 all-steel tubeless radial tire was improved by adjusting the triangle film and the sidewall film.By increasing the width of the film on the apex and reducing the width of the film on the sidewall，and setting a reasonable differential value，the air bubbles on the sidewall of green tire were reduced，the efficiency of building process was improved，and the repair rate of finished tire was greatly reduced.The static load performance，durability and high speed performance of finished tire had little change，and the appearance was improved，the production cost was reduced. |
|
|
查看全文
查看/发表评论 下载PDF阅读器 |
