文章摘要
卢娜,辛振祥.全轮胎胶粉模压弹性体性能的研究[J].橡胶科技,2016,14(1):14-17. 本文二维码信息
二维码（扫一下试试看！）
全轮胎胶粉模压弹性体性能的研究
Properties of Molded Elastomer Using Reclaimed Rubber Powder from Waste Tire
  
DOI：
中文关键词: 轮胎胶粉  模压成型  弹性体  物理性能
英文关键词: reclaimed rubber powder from tire  press molding  elastomer  physical properties
基金项目:
中图分类号:TQ335＋2
作者单位
卢娜 青岛科技大学 高分子科学与工程学院；青岛科技大学 橡塑材料与工程教育部重点实验室 
辛振祥 青岛科技大学 高分子科学与工程学院；青岛科技大学 橡塑材料与工程教育部重点实验室 
摘要点击次数: 1238
全文下载次数: 608
中文摘要:
      采用传统高分子成型设备，改造模压成型模具，制备胶粉弹性体，研究模压弹性体性能的影响因素。结果表明：模压成型压力是影响胶粉模压弹性体性能的重要因素，增大模压成型压力，模压弹性体交联程度增大，物理性能改善；胶粉活化改性使胶粉降解程度增大，不利于胶粉模压成型；以天然橡胶作为粘合剂的胶粉模压弹性体强伸性能明显提高，可以满足部分在静态或低速状态下使用的橡胶制品要求。
英文摘要:
      In this study，the molded elastomer was prepared with reclaimed rubber powder from waste tire using modified press molding molds and conventional press molding equipment.The factors influencing the properties of the molded elastomer were investigated.The experimental results showed that molding pressure was an important factor affecting the performance of molded elastomer.It was found that increase of compression molding pressure would increase the degree of crosslinking and improve the physical properties. Powder activation modification increased the degree of degradation and made it difficult for press molding. The addition of NR as a binder could improve the tensile properties significantly and the molded elastomer met requirements of some rubber products used in the static and low speed applications.
Author NameAffiliation
LU Na School of Polymer Science and Engineering，Qingdao University of Science and Technology；Key Laboratory of Rubber-plastics，Ministry of Education，Qingdao University of Science and Technology 
XIN Zhenxiang School of Polymer Science and Engineering，Qingdao University of Science and Technology；Key Laboratory of Rubber-plastics，Ministry of Education，Qingdao University of Science and Technology 
查看全文   查看/发表评论  下载PDF阅读器