文章摘要
牛家腾,张惠敏,唐跃.Moldflow软件对轿车水箱盖注射成型模具温度的优化[J].橡胶科技,2015,13(9):44-48. 本文二维码信息
二维码（扫一下试试看！）
Moldflow软件对轿车水箱盖注射成型模具温度的优化
Optimization of Injection Molding Temperature of Water Tank Cover by Software Moldflow
  
DOI：
中文关键词: 橡胶注射成型  Moldflow软件  轿车水箱盖  模具温度  体积固化率
英文关键词: rubber injection molding  Moldflow  water tank cover of passenger car  die temperature  volume curing rate
基金项目:
中图分类号:
作者单位
牛家腾 青岛科技大学机电工程学院 
张惠敏 青岛科技大学机电工程学院 
唐跃 青岛科技大学机电工程学院 
摘要点击次数: 1659
全文下载次数: 926
中文摘要:
      用Moldflow软件优化轿车水箱盖注射成型的模具温度。结果表明：模具温度在175 ℃时，胶料充模时间短，充模结束时的体积固化率小，充模后35 s时的体积固化率大。Moldflow软件可以优化橡胶制品的注射成型工艺，缩短工艺和模具设计周期，提高生产效率和产品质量。
英文摘要:
      In this study，the injection molding temperature of water tank cover for passenger car was optimized using Moldlfow.The results showed that，when the mold temperature was set at 175 ℃，the injection time was short，the volume curing rate at the end of injection was low，and the volume curing rate after 35 s was high.Moldflow was effective software to optimize rubber injection molding process，shorten the process and mold design cycle，and improve production efficiency and product quality.
Author NameAffiliation
Niu Jiateng School of Electromechanical Engineering，Qingdao University of Science and Technology 
Zhang Huimin School of Electromechanical Engineering，Qingdao University of Science and Technology 
Tang Yue School of Electromechanical Engineering，Qingdao University of Science and Technology 
查看全文   查看/发表评论  下载PDF阅读器