| Study on Kinematic Simulation of Stepped Direct-pressure Vulcanization Inner Mold of Tire |
| Received:June 21, 2022 Revised:June 22, 2022 |
| DOI：10.12136/j.issn.1000-890X.2024.01.0058 |
| Key Words: tire；stepped direct-pressure vulcanization inner mold；mold design；kinematic simulation |
| Author Name | Affiliation | | TU Yuxiang* | 1. Beijing University of Chemical Technology；2. National Engineering Laboratory of Tire Design and Manufacturing Technology | | JIN Xiaozhe | 1. Beijing University of Chemical Technology；2. National Engineering Laboratory of Tire Design and Manufacturing Technology | | YANG Weimin | 1. Beijing University of Chemical Technology；2. National Engineering Laboratory of Tire Design and Manufacturing Technology | | HE Xuetao | 1. Beijing University of Chemical Technology；2. National Engineering Laboratory of Tire Design and Manufacturing Technology | | YAN Hua | 1. Beijing University of Chemical Technology；2. National Engineering Laboratory of Tire Design and Manufacturing Technology | | TAN Jing | 1. Beijing University of Chemical Technology；2. National Engineering Laboratory of Tire Design and Manufacturing Technology | | JIAO Zhiwei | 1. Beijing University of Chemical Technology；2. National Engineering Laboratory of Tire Design and Manufacturing Technology |
|
| Hits: 820 |
| Download times: 682 |
| Abstract: |
| A kinematic simulation study was conducted on the stepped direct-pressure vulcanization
inner mold（referred to as the stepped inner mold） of 225/40R18 tire. By setting the connecting rods and
motion pairs，as well as using the STEP function to control the movement of the inner mold，the displacements
of observation points set at the center positions of the piston outer rod，piston inner rod，wide drum tile and
narrow drum tile were obtained through the simulation. The results showed that the movement of the stepped
inner mold were smooth and continuous without interference. |
|
View Full Text
View/Add Comment Download reader |
| Close |
