| 混炼成型一体机最佳填充因数的试验研究 |
| Experimental Study on Ｏptimum Filling Factor of Integrated Mixing and Molding Machine |
| |
| DOI： |
| 中文关键词: 密炼机 同步转子 转子构型 混炼成型 填充因数 |
| 英文关键词: mixer synchronous rotor rotor configuration mixing-molding filling factor |
| 基金项目:国家自然科学基金资助项目（51345006）；青岛市科技计划基础研究项目［（11-2-4-3-（11）-jch）］；山东省高等学校科技计划项目（J09LD10） |
|
| 摘要点击次数: 921 |
| 全文下载次数: 537 |
| 中文摘要: |
| 利用基于实验室现有小型同步转子密炼机的试验平台，在冷却水温度、压砣压力、转子转速一致的条件下，改变填充因数，对5对不同构型转子进行试验研究。结果表明，混炼过程存在最佳填充因数。通过对比试验结果，得到全钢子午线轮胎胎面胶最佳填充因数为0.60～0.65。 |
| 英文摘要: |
| By using a small lab mixer with synchronous rotor，under the same condition of cooling water temperature，ram pressure and rotor speed，five different configurations of the rotor were experimentally studied with varied filling factors.The results showed that there was an optimal filling factor in the mixing process.Based on the experimental results，the optimal filling factor of the tread compound for all steel radial tire was 0.60～0.65. |
|
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
