| 吴健,陈达,陈龙,王友善,粟本龙,崔志博.复杂工况下航空轮胎胎体帘线力学性能研究[J].轮胎工业,2020,40(7):0401-0405 |
二维码（扫一下试试看！） |
| 复杂工况下航空轮胎胎体帘线力学性能研究 |
| Study on the Mechanical Properties of Aircraft Tire Carcass Cord under Complex Conditions |
| 投稿时间：2019-09-29 修订日期：2019-09-29 |
| DOI：10.12135/j.issn.1006-8171.2020.07.0401 |
| 中文关键词: 航空轮胎 胎体帘线 充气压力 负荷 应力 有限元分析 |
| 英文关键词: aircraft tire tire carcass cord inflation pressure load stress finite element |
| 基金项目: |
| 中图分类号: |
|
| 摘要点击次数: 771 |
| 全文下载次数: 574 |
| 中文摘要: |
| 基于某型号航空轮胎的几何尺寸与材料参数，采用有限元方法建立轮胎二维和三维有限元模型，研究不同充气压力和负荷下胎体帘线应力和轮胎变形规律。结果表明：随着充气压力增大，胎体帘线应力增大；随着负荷的增大，胎体帘线应力增大，最大应力出现在轮胎中心高度上的胎肩附近；充气后胎体帘线在中间产生凸起，加载后离地端帘线变形类似进一步充气，而接地端帘线中间位置与路面贴合，胎侧产生较大凸起。可通过结构设计改善航空轮胎骨架材料力学性能。 |
| 英文摘要: |
| Based on the geometric size and material parameters of a certain type of aircraft tire，two-dimensional and three-dimensional finite element models of tire were established by using the finite element method.The tire cord stress and tire deformation under different inflation pressures and loads were investigated.The results showed that，with the increase of inflation pressure，the stress of cord was increased.With the increase of load，the stress of tire cord was increased，and the maximum stress appeared near the shoulder of tire center height.After inflation，the tire cord was bulged in the middle.After loading，the deformation of the cord away from the ground end was similar to further inflation.However，the middle position of the cord close to the ground end fit the road surface，and the sidewall was bulged greatly.The mechanical properties of aircraft tire frame material could be improved by structural design. |
|
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
