文章摘要
李庆瑞,张文涛,张玲玲,张开开,谢国振,王 聪,扈海建,冯海真.全钢工程机械子午线轮胎面接头开裂原因分析和解决措施[J].橡胶科技,2024,22(12):0694-0696. 本文二维码信息
二维码(扫一下试试看!)
全钢工程机械子午线轮胎面接头开裂原因分析和解决措施
Cause Analysis and Solutions for Tread Joint Cracking of All-steel Off-The-Road Radial Tire
投稿时间:2023-08-28  修订日期:2023-08-28
DOI:10.12137/j.issn.2095-5448.2024.12.0694
中文关键词: 全钢工程机械子午线轮胎  胎面  接头开裂
英文关键词: all-steel off-the-road radial tire  tread  joint cracking
基金项目:
中图分类号:
作者单位E-mail
李庆瑞* 风神轮胎股份有限公司 lqr-3155@163.com 
张文涛 风神轮胎股份有限公司  
张玲玲 风神轮胎股份有限公司  
张开开 风神轮胎股份有限公司  
谢国振 风神轮胎股份有限公司  
王 聪 风神轮胎股份有限公司  
扈海建 风神轮胎股份有限公司  
冯海真 风神轮胎股份有限公司  
摘要点击次数: 192
全文下载次数: 128
中文摘要:
      分析全钢工程机械子午线轮胎面接头开裂原因,并提出相应的解决措施。通过增大挤出裁刀刀刃长度和刀枕高度、胎面长度,取消胎面底层聚乙烯膜,在成型过程中使用钢丝刷将胎面接头边部打毛等措施,胎面接头开裂问题基本解决,缺陷率由最高时的15%降低至0.16%。
英文摘要:
      The causes of tread joint cracking of all-steel off-the-road radial tire were analyzed,and the corresponding solutions were proposed.By increasing the blade length and blade pillow height of the extrusion cutter,and the length of the tread,eliminating the use of polyethylene film at the bottom of the tread,and roughening the edges of the tread joint with a steel wire brush during the building process,the problem of tread joint cracking was basically solved,and the defect rate was reduced from the highest 15% to 0.16%.
Author NameAffiliationE-mail
LI Qingrui Aeolus Tire Co., Ltd lqr-3155@163.com 
ZHANG Wentao Aeolus Tire Co., Ltd  
ZHANG Lingling Aeolus Tire Co., Ltd  
zhang kaikai Aeolus Tire Co., Ltd  
XIE Guozhen Aeolus Tire Co., Ltd  
WANG cong Aeolus Tire Co., Ltd  
HU Haijian Aeolus Tire Co., Ltd  
FENG Haizhen Aeolus Tire Co., Ltd  
查看全文   查看/发表评论  下载PDF阅读器