文章摘要
本文二维码信息
二维码(扫一下试试看!)
子午线轮胎钢丝帘布粘合性能的研究
Study on Adhesion Property of Steel Cord in Radial Tire
Received:September 11, 2019  Revised:September 11, 2019
DOI:10.12137/j.issn.2095-5448.2020.05.0262
中文关键词: 子午线轮胎;钢丝帘布;粘合性能;剥离力;游离硫含量
英文关键词: radial tire;steel cord;adhesion property;peel strength;free sulfur content
基金项目:
中图分类号:
Author NameAffiliationE-mail
lI Peng Triangle Tire Co.,Ltd lpeng218@163.com 
CUI Xiao Triangle Tire Co.,Ltd  
LYU Dandan Triangle Tire Co.,Ltd  
DONG LingBo* Triangle Tire Co.,Ltd donglingbo@triangle.com.cn 
Hits: 1721
Download times: 16
中文摘要:
      研究钢丝帘布停放时间、钢丝粘合胶混炼工序加硫温度和钢丝帘布压延温度对胶料中游离硫含量以及钢丝帘布表面粘合性能和剥离力的影响。结果表明:胶料中游离硫含量高会造成喷霜,从而导致钢丝帘布表面粘合性能降低;在低温下停放时,钢丝帘布停放时间对胶料中游离硫含量影响不大,但钢丝帘布表面因受到氧化导致其粘合性能降低,停放时间对钢丝帘布间的剥离力基本没有影响;钢丝粘合胶混炼工序中加硫温度必须控制在90~100 ℃范围内;压延温度低于100 ℃时,钢丝帘布中游离硫含量变化不大,钢丝帘布表面粘合性能基本不变,压延温度高于100 ℃时,钢丝帘布中游离硫含量快速增大,钢丝帘布表面粘合性能降低,钢丝帘布压延供胶温度应控制在85~95 ℃范围内。
英文摘要:
      The effects of the storage time of the steel cord,the temperature of adding sulfur in the mixing process of steel-bonded compound and the calendering temperature of the steel cord on the free sulfur content in the compound,the surface adhesion property and peeling force of the steel cord were studied.The results showed that,the high free sulfur content in the compound would caused blooming,which would reduce the surface adhesion property of the steel cord.When the steel cord was parked at low temperature,its storage time had little effect on the free sulfur content in the compound,but the surface adhesion property of the steel cord was reduced due to oxidation,and the storage time had little effect on the peeling force. In the mixing process,when sulfur added temperature must be controlled in the range of 90~100 ℃.When the calendering temperature was lower than 100 ℃,the free sulfur content in the steel cord changed little,and the surface adhesion property of the steel cord was basically unchanged.When the calendering temperature was higher than 100 ℃,the free sulfur content in the steel cord increased rapidly,and the surface adhesion property of the steel cord decreased.The feeding temperature of steel cord calendering was controlled in the range of 85~95 ℃.
View Full Text   View/Add Comment  Download reader
Close